Special Tools

J 45059 Angle Meter

1. Install the dowel pins - cylinder head locator, if necessary.
2. Install a new cylinder head gasket.



3. Install the cylinder head.



4. Install new cylinder head bolts.

Caution: Refer to Fastener Caution in the Preface section.




5. Tighten the new cylinder head bolts in the following sequence:

5.1.	Tighten the (14) long cylinder head bolts in sequence to 30 N·m (22 lb ft).

5.2.	Use J 45059 meter to tighten the cylinder head bolts in sequence an additional 155 degrees.

5.3.	Tighten the (2 Short) end bolts to 7 N·m (62 lb in).

Use J 45059 meter to tighten the short cylinder head end bolts an additional 60 degrees.

5.4.	Tighten the (1 Long) end bolt to 7 N·m (62 lb in).

Use J 45059 meter to tighten the long cylinder head end bolt an additional 120 degrees.