Special Tools
• | EN-48034 Crankshaft Balancer Installer
|
- Install the crankshaft balancer using
EN-48034 installer
.
- Remove
EN-48034 installer
.
- Hold the flywheel or back of the crankshaft. The crankshaft balancer does not have a keyway so the crankshaft could turn when tightening, causing an improper torque.
Caution: Refer to Fastener Caution in the Preface section.
- Install the crankshaft balancer washer and new bolt.
4.1. | Tighten the new crankshaft balancer bolt while holding the back to
150 N·m (110 lb ft). |
4.2. | Use
J 45059 meter
to tighten the crankshaft balancer bolt an additional
180 degrees. |