Special Tools
J 45299 Engine Preluber
Caution: Refer to Fastener Caution in the Preface section.
Note: A constant/continuous flow of clean engine oil is required to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.
- Remove the engine oil filter, fill with clean engine oil, and reinstall. Tighten the oil filter to
30 N·m (22 lb ft).
- Remove the engine block oil gallery plug (1).
- Install the M16 x 1.5 adapter P/N 509375.
- Install the flexible hose to the adapter and open the valve.
- Pump the handle on
J 45299 preluber
to flow a minimum of 1-2 quarts of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
- Close the valve and remove the flexible hose and adapter from the engine.
- Install the engine block oil gallery plug. Tighten the oil pressure sensor to
35 N·m (26 lb ft).
- Top off the engine oil to the proper level.