Note: Note the position and direction of the engine flywheel before removal.
Note: The flywheel does not use a locating pin for alignment and will not initially seat against the crankshaft flange, but will be pulled onto the crankshaft by the engine flywheel bolts. This procedure requires a three stage tightening process.
Caution: Refer to Fastener Caution in the Preface section.
3.1. | Tighten the bolts a first pass in sequence to 20 N·m (15 lb ft). |
3.2. | Tighten the bolts a second pass in sequence to 50 N·m (37 lb ft). |
3.3. | Tighten the bolts a final pass in sequence to 100 N·m (74 lb ft). |