GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Isuzu
🢒
2009
🢒
Ascender - 4WD
🢒
Diagnostic Navigation
🢒
Vehicle Diagnostic Information
🢒 Evaporative Emission Canister Replacement
Removal Procedure
Remove the spare tire. Reference the owners manual for additional information if needed.
Raise the vehicle. Refer to
Lifting and Jacking the Vehicle
.
Disconnect the evaporative emission (EVAP) vapor pipe (1) from the EVAP canister.
Disconnect the EVAP purge pipe (2) from the EVAP canister.
Disconnect the EVAP vent pipe (3) from the EVAP canister.
Remove the bolts (1) from the EVAP mounting bracket (2).
Remove the EVAP canister and bracket assembly from the vehicle.
Remove the bolt (1) attaching the EVAP canister (3) to the mounting bracket (2).
Remove the EVAP canister (3) from the mounting bracket (2).
Remove the EVAP retaining bracket (2) from the EVAP canister (3) by releasing the retaining bracket clip (1) from the EVAP canister (3).
Installation Procedure
Install the EVAP retaining bracket (2) to the EVAP canister (3) ensuring the retaining bracket clip (1) is fully engaged.
Install the EVAP canister (3) to the mounting bracket (2).
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the bolt (1) attaching the EVAP canister (3) to the mounting bracket (2) and tighten to
20 N·m (15 lb ft)
.
Install the EVAP canister and bracket assembly to the vehicle.
Install the bolts (1) to the EVAP mounting bracket (2) and tighten to
20 N·m (15 lb ft)
.
Connect the evaporative emission (EVAP) vapor pipe (1) to the EVAP canister.
Connect the EVAP purge pipe (2) to the EVAP canister.
Connect the EVAP vent pipe (3) to the EVAP canister.
Lower the vehicle.
Install the spare tire. Reference the owners manual for additional information if needed.