J 45059 Angle Meter
Note: Refer to the pin stamp on the crankshaft main bearing caps for sequence and direction of installation. The pin stamp arrow points to the front of the engine.
Note: The crankshaft main bearing cap stiffener is directional. The end marked front goes to the front.
Caution: Refer to Fastener Caution in the Preface section.
9.1. | Tighten the crankshaft main bearing cap bolts to 25 N·m (18 lb ft) in sequence. |
9.2. | Use J 45059 meter to tighten the crankshaft main bearing cap bolts an additional 180 degrees. |
10.1. | Thrust the crankshaft forward or rearward. |
10.2. | Insert a feeler gage between the thrust crankshaft bearing and the bearing surface of the crankshaft and measure the bearing clearance. Refer to Engine Mechanical Specifications for the proper clearance. |
10.3. | If the bearing clearance is not within specifications, inspect the thrust surfaces for nicks, gouges or raised metal. Minor imperfections may be removed with a fine stone. |