Removal Procedure
Note: It is not necessary to lower the steering column to remove the radio antenna module.
- Remove the navigational radio. Refer to
Radio Replacement.
- Disconnect the electrical connector from the navigational radio (1).
- Partially remove the instrument panel (I/P) assembly from the I/P structure, to gain access to the antenna module retaining screw. Refer to
Instrument Panel Assembly Replacement.
- Remove the screw retaining the radio antenna module to the cross-car beam (2).
- Remove the antenna module from the vehicle.
Installation Procedure
- Install the antenna module to the vehicle.
- Install the screw retaining the antenna module to the cross-car beam (2).
Caution: Refer to Fastener Caution in the Preface section.
- Tighten the screw.
Tighten
Tighten the screw to 2.5 N·m (22 lb in).
- Install the I/P assembly. Refer to
Instrument Panel Assembly Replacement.
- Connect the electrical connector to the navigational radio (1).
- Install the navigational radio. Refer to
Radio Replacement.