GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Isuzu
🢒
2009
🢒
Ascender - 4WD
🢒
Diagnostic Navigation
🢒
Vehicle Diagnostic Information
🢒 Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
Raise the vehicle. Refer to
Lifting and Jacking the Vehicle
.
Remove the engine shield. Refer to
Engine Protection Shield Replacement
.
Remove the electrical connector from the oil pressure switch.
Remove the oil pressure switch.
Installation Procedure
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the oil pressure switch and tighten to
20 N·m (15 lb ft)
.
Install the electrical connector to the oil pressure switch.
Install the engine shield. Refer to
Engine Protection Shield Replacement
.
Lower the vehicle.