Removal Procedure
- Remove the rear seat bracket trim cover.
- Remove the hydraulic jack from the jack stowage area, on the left side only.
- Position the seat cushion assembly in order to gain access to the 2 rear seat mounting nuts.
- Remove the 2 mounting nuts.
- Remove the seat cushion assembly from the vehicle.
Installation Procedure
- Position the seat cushion assembly to the vehicle.
Caution: Refer to Fastener Caution in the Preface section.
- Install the 2 nuts that retain the seat cushion assembly to the floor panel.
Tighten
Tighten the rear seat mounting nuts to 45 N·m (33 lb ft).
- Install the hydraulic jack into the jack stowage area, on the left side only.
- Adjust the seat cushion assembly to the latched position.
- Install the rear mount trim cover.