Special Tools
J 39400-A Halogen Leak Detector
Removal Procedure
- Disconnect the A/C low pressure switch electrical connector.
- Remove the A/C low pressure switch (2) from the accumulator (1).
- Remove and discard the O-ring seal from the A/C low pressure switch port on the accumulator.
Installation Procedure
- Install the new O-ring seal. Refer to
O-Ring Replacement.
Caution: Refer to Fastener Caution in the Preface section.
- Install the A/C low pressure switch (2) to the accumulator (1). Tighten the A/C low pressure switch to
4.8 N·m (42 lb in)
- Connect the A/C low pressure switch electrical connector.
- Leak test the fittings of the components using the
J 39400-A .