GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2009 🢒 Ascender - 4WD 🢒 Safety and Security 🢒 Supplemental Inflatable Restraints 🢒 Instrument Panel Inflatable Restraint Module Replacement

Removal Procedure

    Warning: Refer to SIR Warning in the Preface section.

    Warning: Refer to SIR Inflator Module Handling and Storage Warning in the Preface section.

  1. Disable the SIR System. Refer to SIR Disabling and Enabling.

    2. Object Number: 712793 Size: SH
  2. Remove the passenger side instrument panel (I/P) access panel.

    3. Object Number: 762389 Size: SH
  3. Remove the passenger air duct extension screw (1).

    4. Object Number: 762387 Size: SH
  4. Remove the air duct extension from the front of the I/P.

    5. Object Number: 762390 Size: SH
  5. Open the I/P compartment door to a full down position.
  6. Remove the 2 lower passenger supplemental inflatable restraint (PSIR) inflator module retaining bolts (1).

    7. Object Number: 846922 Size: SH
  7. Remove the 2 side retaining nuts from the PSIR inflator module.

    8. Object Number: 742163 Size: SH
  8. Remove the PSIR inflator module from the front of the I/P carrier.
  9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.

Installation Procedure

    Object Number: 742163 Size: SH
  1. Install the PSIR inflator module to the front of the I/P carrier.

    2. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 846922 Size: SH
  2. Install the 2 side retaining nuts to the PSIR inflator module.

    3. Tighten
    Tighten the nuts until fully driven, seated and not stripped.


    Object Number: 762390 Size: SH
  3. Install the 2 retaining bolts (1) to the PSIR inflator module.

    4. Tighten
    Tighten the bolts until fully driven, seated and not stripped.


    Object Number: 762387 Size: SH
  4. Install the passenger air duct extension though the front of the I/P.

    5. Object Number: 762389 Size: SH
  5. Install the passenger air duct extension screw (1).

    6. Tighten
    Tighten the screw to 2.5 N·m (22 lb in).

  6. Close the I/P compartment door.

    7. Object Number: 712793 Size: SH
  7. Install the passenger side I/P access panel.
  8. Enable the SIR System. Refer to SIR Disabling and Enabling.