GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2009 🢒 I-290 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Accelerator Pedal Position Sensor Replacement

Removal Procedure

    Object Number: 1352013 Size: SH
  1. Disconnect the accelerator pedal position (APP) sensor electrical connector.
  2. Remove the APP sensor nuts.
  3. Remove the APP sensor from the vehicle.

Installation Procedure

    Object Number: 1352013 Size: SH
  1. Position the APP sensor over the studs.

    2. Caution: Refer to Fastener Caution in the Preface section.

  2. Install the APP sensor nuts.

    3. Tighten
    Tighten the APP sensor mounting nuts to 9 N·m (80 lb in).

  3. Connect the APP sensor electrical connector.
  4. Inspect below the pedal for binding, to ensure full range of motion.