For 1990-2009 cars only
Removal Procedure
- Remove the 2 screws securing the switch plate assembly to the door trim panel.
- Lift the switch plate up and out of the door trim panel.
- Disconnect the electrical connectors from the switch module.
- Remove the switch plate assembly from the vehicle.
- If replacing only the switch module, remove the module from the switch plate.
- If replacing only the switch plate, retain the switch module for transfer.
Installation Procedure
- Install the switch module to the switch plate.
- Connect the electrical connector to the switch module.
- Install the rear switch plate assembly to the door trim panel with the 2 screws and tighten to 2 N·m (18 lb in).
Caution: Refer to Fastener Caution in the Preface section.
