Preliminary Procedures

1. Turn the ignition switch to the OFF position.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.

1

Trailer Lamp Control Module Bolt (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Procedure

Loosen, but do not remove the bolts. It is not necessary to completely remove the bolts.

Tighten
9 N·m (80 lb in)

2

Trailer Lamp Control Module

Procedure

1. Disconnect the electrical connector.
2. Slide the module upward to remove.
3. If installing a new trailer lamp control module, program the module. Refer to Control Module References.