Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC P025A: Fuel Pump Control Module Enable CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open or High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
FPCM Control | P025A | P025A | -- | -- |
Circuit/System Description
The engine control module (ECM) supplies voltage to the fuel pump flow control module (FPCM) when the ECM detects that the ignition is on. The voltage from the ECM to the FPCM remains active for 2 seconds, unless the engine is in crank or run. While this voltage is being received, the FPCM supplies a varying voltage to the fuel tank pump module in order to maintain the desired fuel rail pressure.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
The GMLAN serial data message from the ECM to the FPCM does not agree with the state of the control enable voltage signal supplied from the ECM to the FPCM for more than 2 seconds.
Action Taken When the DTC Sets
DTC P025A is a Type A DTC.
Conditions for Clearing the DTC
DTC P025A is a Type A DTC.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Electrical Information Reference
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the FPCM.
- Ignition OFF, connect a test lamp between the control circuit terminal 13 and ground.
- Ignition ON, command the fuel pump ON and OFF with a scan tool ECM fuel pump output control. The test lamp should turn ON and OFF when changing between the commanded states.
- If all circuits test normal, replace the FPCM.
| ⇒ | If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the ECM. |
| ⇒ | If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for ECM or FPCM replacement, setup, and programming
