For 1990-2009 cars only
Removal Procedure
- Disconnect the tail/turn signal lamp wiring connectors at the rear of the vehicle.
- Remove the tail lamp assembly. Refer to Tail Lamp Replacement.
- Open the fuel filler door.
- Remove the fuel filler neck. Refer to Fuel Tank Filler Pipe Housing Replacement.
- Remove the endgate. Refer to Endgate Replacement.
- Remove the pickup box fasteners (1) from the frame rails.
- With the an assistant remove the box from the vehicle.
Installation Procedure
- Align the pickup box on the frame rails.
- Loosely install the pickup box fasteners (1) to the frame rails and tighten the bolts to 85 N·m (63 lb ft).
- Install the endgate. Refer to Endgate Replacement.
- Fasten the screws and the push-pin around the fuel filler neck.
- Close the fuel filler door.
- Install the tail lamp assembly. Refer to Tail Lamp Replacement.
- Connect the tail lamp wiring connectors at the rear of the vehicle.
Caution: Refer to Fastener Caution in the Preface section.
