For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category |
Circuit/System Description
The instrument panel cluster (IPC) displays the vehicle speed based on the vehicle speed information from the engine control module (ECM). The ECM sends the vehicle speed information via the serial data circuit to the body control module (BCM). The BCM then sends the information via the serial data circuit to the IPC in order to display the vehicle speed and accumulated miles traveled.
Reference Information
Schematic Reference
Connector End View Reference
Description and Operation
Instrument Cluster Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
- Ignition ON, perform the speedometer sweep test with the scan tool. Verify that the speedometer sweeps from its low to high position.
- Ignition OFF, raise the vehicles drive wheels.
- Engine ON, transmission in drive or 1st gear, verify the scan tool Vehicle Speed Sensor parameter matches the speedometer display.
| ⇒ | If the speedometer gage does not sweep from its low to high position, replace the IPC. |
| ⇒ | If the Vehicle Speed Sensor parameter does not match the speedometer display, replace the IPC. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Control Module References for IPC replacement, setup, and programming
