For 1990-2009 cars only
Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC C0245 : Wheel Speed Sensor Frequency ErrorCircuit/System Description
The wheel speed sensor receives a 12-volt reference voltage from the electronic brake control module (EBCM). As the wheel spins, the wheel speed sensor sends the EBCM a DC square wave signal via the wheel speed sensor output circuit. The EBCM uses the frequency of the square wave signal to calculate the wheel speed.
Conditions for Running the DTC
| • | Ignition voltage is greater than 10 volts. |
| • | Vehicle must be moving at a speed greater than 30 km/h. |
Conditions for Setting the DTC
| • | Wheel speed differences between one wheel and the others is greater than 20 percent. |
| • | The fault must be present for greater than 60 seconds. |
Action Taken When the DTC Sets
| • | The EBCM disables the Antilock Brake System (ABS)/Traction Control System (TCS)/Vehicle Stability Enhancement System (VSES) for the duration of the ignition cycle. |
| • | A DIC message and/or a warning indicator may be displayed. |
Conditions for Clearing the DTC
| • | The condition for setting the DTC is no longer present. |
| • | The EBCM clears the history DTC when a current DTC is not detected in 50 consecutive drive cycles. |
Diagnostic Aids
| • | Faulty wheel speed sensor will not set this DTC. |
| • | A vehicle using a space saver spare will not set this code. |
Reference Information
Schematic Reference
Antilock Brake System Schematics
Connector End View Reference
Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Inspect for one tire that has improper air pressure or improper size.
