DTC C0244 or P1689. Isuzu I-370 2008

For 1990-2009 cars only

Makes 🢒 Isuzu 🢒 2008 🢒 I-370 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 DTC C0244 or P1689

Diagnostic Instructions

•	Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.

•	Review Strategy Based Diagnosis for an overview of the diagnostic approach.

•	Diagnostic Procedure Instructions provides an overview of each diagnostic category.

DTC Descriptors

DTC C0244 00: Pulse Width Modulated (PWM) Delivered Torque

DTC P1689 00: Traction Control Delivered Torque Output Circuit

The electronic brake control module (EBCM) and the powertrain control module (PCM) simultaneously control the Traction Control System (TCS). The PCM sends a Delivered Torque message via a pulse width modulated (PWM) signal to the EBCM. The duty cycle of the signal is used to determine how much engine torque the PCM is delivering.

Conditions for Running the DTC

The ignition is ON and the engine is running.

Conditions for Setting the DTC

•	Pulse signals from the Delivered Torque signal are not detected or are abnormal.

•	The Duty Cycle is less than 5 percent or more than 95 percent.

Action Taken When the DTC Sets

•	The EBCM disables TCS and vehicle stability enhancement system (VSES) for the duration of the ignition cycle.

•	The Stability Caution indicator turns on.

•	The driver information center (DIC) displays the TRACTION FAILED message.

•	The DIC displays the SERVICE STAB SYS message.

Conditions for Clearing the DTC

•	The condition for the DTC is no longer present and the DTC is cleared with a scan tool.

•	The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Diagnostic Aids

Thoroughly inspect connections or circuitry that may cause an intermittent malfunction.

Reference Information

Electrical Information Reference

•	Circuit Testing

•	Connector Repairs

•	Testing for Intermittent Conditions and Poor Connections

•	Wiring Repairs

Scan Tool Reference

Control Module References for scan tool information.

Circuit/System Testing

Use a scan tool in order to clear the DTCs. Cycle the ignition to OFF and then start the engine. A current failure will set a DTC.

⇒	If the DTC does not reset, go to Diagnostic Aids.

Turn OFF the ignition and disconnect the PCM harness connector. At the PCM harness connector, use a DMM to measure for 12 volts on the delivered torque circuit. Turn ON the ignition.

⇒	If the voltage is below 10 volts, test for an open or short to ground on the requested torque circuit or replace the EBCM/brake pressure modulator valve (BPMV) assembly.

Connect one end of a test lamp to ground. With the DMM still connected to the PCM harness connector, touch the other end of the test lamp to the DMM lead connected to the PCM harness connector. The DMM voltage reading should drop below 0.5 volts.

⇒	If the voltage does not drop to below 0.5 volts, check for a short to voltage on the requested torque circuit. If a short to voltage cannot be found, replace the EBCM/brake pressure modulator valve (BPMV) assembly.

Repair Instructions

Perform the Diagnostic Repair Verification after completing the diagnostic procedure.

Control Module References for EBCM/BPMV or PCM replacement, setup, and programming