GM Service Manual Online
For 1990-2009 cars only
Makes
🢒
Isuzu
🢒
2009
🢒
I-370
🢒
Power and Signal Distribution
🢒
Wiring Systems and Power Management
🢒 Ignition Lock Cylinder Case Replacement
Removal Procedure
Remove the ignition lock cylinder. Refer to
Ignition Lock Cylinder Replacement
.
Remove the multifunction turn signal switch housing. Refer to
Multifunction Turn Signal Switch Housing Replacement
.
Remove the shear bolt from the ignition lock cylinder case using a hammer and chisel.
Remove the ignition lock cylinder case.
Installation Procedure
Install the ignition lock cylinder case.
Caution:
Refer to
Fastener Caution
in the Preface section.
Install the ignition lock cylinder case bolt and tighten it until the head shears off.
Install the multifunction turn signal switch. Refer to
Multifunction Turn Signal Switch Housing Replacement
.
Install the ignition lock cylinder. Refer to
Ignition Lock Cylinder Replacement
.
The passlock sensor is part of the ignition switch. If replacing the ignition switch, a passlock relearn will be needed. Refer to
Control Module References
.