GM Service Manual Online
For 1990-2009 cars only

Electronic Brake Control Module Replacement JE3

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.

  1. Disconnect the negative battery cable.

  2. Object Number: 1500650  Size: SH
  3. Remove the electrical connector bolt from electronic brake control module (EBCM).
  4. Disconnect the electrical connector from EBCM.
  5. Remove the 4 bolts and 4 washers and remove the EBCM from the bracket.

Installation Procedure


    Object Number: 1500650  Size: SH
  1. Install EBCM to bracket.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the 4 EBCM mounting bolts and washers.
  4. Tighten
    Tighten the EBCM mounting bolts to 8 N·m (71 lb in).

  5. Connect the EBCM electrical connector.
  6. Install the EBCM electrical connector bolt.
  7. Tighten
    Tighten the EBCM electrical connector bolt to 2 N·m (18 lb in).

  8. Connect the negative battery cable.
  9. Perform the diagnostic system check.