The turbocharger learn procedure is required when the following service procedures have been performed:
• | The turbocharger vane position control solenoid valve replacement |
• | The turbocharger vane position sensor replacement |
• | The engine control module (ECM) replacement |
• | The turbocharger replacement |
• | Any service to the turbocharger components |
Failure to perform the turbocharger learn procedure may result in setting DTCs.
- Install a scan tool.
- Monitor the ECM for DTCs with a scan tool. If any DTCs are set, refer to
Diagnostic Trouble Code (DTC) List - Vehicle
.
- Perform the following steps:
• | Block the drive wheels. |
• | The vehicle must be in Park or Neutral. |
• | Start and idle the engine. |
• | Allow the engine operating temperature to exceed 72°C (162°F). |
Important: While the learn procedure is in progress, the throttle should remain at idle. DO NOT change the accelerator pedal position during this procedure.
- Allow the ECM to learn the new turbocharger positions.
- Clear any DTCs. The turbocharger learn procedure is complete. If any DTCs reset, refer to
Diagnostic Trouble Code (DTC) List - Vehicle
.
- Turn OFF the ignition for 30 seconds after the learn procedure is completed successfully.