Removal Procedure
- Tilt the cab. Refer to
Cab Tilting
.
- Disconnect the electrical connector from the fuel pressure sensor (5).
- Remove the fuel pressure sensor (5) from the fuel rail.
Inspection Procedure
- Inspect the sensor for damage.
- Replace the sensor if the sensor is worn or damaged.
- Inspect the packing for cracks or leaks.
- Replace the packing if the packing is worn or damaged.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the fuel pressure sensor (5) into the fuel rail.
Tighten
Tighten the sensor to 20 N·m (15 lb ft).
- Connect the electrical connector to the fuel pressure sensor (5).
- Lower the cab.