GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2005 🢒 Isuzu MD F-Series 🢒 Suspension 🢒 Front Suspension 🢒 Front Spring Hanger Replacement

Removal Procedure
  1. Set the parking brake.
  2. Block the vehicle's rear wheels.

    3. Notice: Do not use the front crossmember to support the vehicle or the crossmember may buckle.

    Important: Raise the frame high enough in order to allow the spring to clear the front spring bracket when you lower the axle.

  3. Raise the frame until the front tires clear the floor.
  4. Support the frame using suitable safety stands.
  5. Support the axle with a jack.

    6. Object Number: 201719 Size: SH
  6. Remove the following components from the lower mounting brackets (7):
    7. • The nut (10)
    • The washer (9)
    • The insulator (8)
  7. Remove the shock absorbers (5) from the lower mounting brackets (7). Push the shock absorbers into the fully retracted position.

    8. Object Number: 376827 Size: SH
  8. Remove the following components from the spring and the hanger:
    9. • The spring eye bolt nut (4)
    • The washers
    • The bolt (7)
  9. Lower the axle far enough to allow the spring (5) to clear the bracket and allow removal of the bracket (2).

    10. Object Number: 934158 Size: SH
  10. Remove the following components from the side member:
    11. • The spring hanger nuts
    • The washers
    • The bolts
    • The spring hanger

Installation Procedure

    Object Number: 934158 Size: SH
  1. Install the hanger to the side member with the following parts:
    2. • The bolts
    • The washers
    • The spring hanger nuts

    Notice: Refer to Fastener Notice in the Preface section.

  2. Tighten the hanger mounting bolts.

    3. Tighten

        • Tighten the nuts to 175 N·m (129 lb ft) - Web Side.
        • Tighten the nuts to 175 N·m (129 lb ft) - Flange Side.

    Object Number: 376827 Size: SH
  3. Raise the spring in order to align the spring eye and spring hanger holes.
  4. Install the following components in the spring and the hanger:
    5. • The spring eye bolt (7)
    • The washers
    • The nut (4)

    Tighten
    Tighten the eye bolt to 330 N·m (243 lb ft).


    Object Number: 201719 Size: SH
  5. Install the flat washer (6) and the insulator (13) onto the shock absorber lower stem.
  6. Install the shock absorber (5) into the lower mounting bracket (7).
  7. Install the following components:
    8. • The insulators (8)
    • The flat washers (9)
    • The nut (10)

    Tighten
    Tighten the lower shock absorber nut to 85 N·m (62 lb ft).

  8. Remove the safety stands and lower the vehicle.