GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2005 🢒 Isuzu MD F-Series 🢒 Body 🢒 Instrument Panel, Gages, and Console 🢒 Ignition and Start Switch Replacement

Removal Procedure

    Object Number: 228496 Size: MH
  1. Remove the steering wheel (3). Refer to Steering Wheel Replacement .
  2. Remove the left and right side cowl half screws.
  3. Remove one of the fasteners from the cowl rear dust flap.
  4. Remove the following component from the upper steering shaft assembly (7):
    5. • The right side cowl half (5)
    • The left side cowl half (12)
  5. Disconnect the electrical connector from the ignition switch (6).
  6. Remove the following components from the upper steering shaft assembly (7):
    7. 6.1. The ignition switch screws
    6.2. The wiring harness clamp
    6.3. The ignition switch (6)

Installation Procedure

    Object Number: 228496 Size: MH
  1. Install the ignition switch (6) to the upper steering shaft assembly (7).

    2. Secure the ignition switch (6) to the steering shaft assembly with the wiring harness clamp and the screws.

  2. Connect the electrical connector to the ignition switch (6).
  3. Install the following components to the upper steering shaft assembly (7):
    4. • The right side cowl half (5)
    • The left side cowl half (12)
    • The cowl rear dust flap
  4. Secure the cowl halves with screws.
  5. Install the steering wheel (3). Refer to Steering Wheel Replacement .