GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics

Connector End View Reference: Lighting Systems Connector End Views

DEFINITION: The daytime running lamps operate properly, but the daytime running lamp indicator is inoperative.

1

Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

2

  1. Start the engine.
  2. Place the headlamp switch in the OFF position.
  3. Ensure the park brake is disengaged.

Does the daytime running lamp (DRL) indicator illuminate?

Go to Testing for Intermittent Conditions and Poor Connections

Go to Step 3

3

  1. Disconnect the DRL indicator lamp relay.
  2. Connect a fused jumper wire between the DRL indicator control circuit of the DRL indicator lamp relay and ground.

Does the DRL indicator illuminate?

Go to Step 4

Go to Step 5

4

Connect a fused jumper wire between the DRL indicator control circuit of the DRL indicator lamp relay and the switch side output circuit of the DRL indicator lamp relay.

Does the DRL indicator illuminate?

Go to Step 7

Go to Step 10

5

  1. Remove the instrument panel cluster (IPC).
  2. Probe the voltage supply circuit of the DRL indicator at the IPC connector with a test lamp that is connected to ground.

Does the test lamp illuminate?

Go to Step 6

Go to Step 11

6

  1. Replace the DRL indicator lamp relay.
  2. Connect a test lamp between the voltage supply circuit of the DRL indicator at the IPC connector and the DRL indicator control circuit at the IPC connector.

Does the test lamp illuminate?

Go to Step 8

Go to Step 12

7

Inspect for poor connections at the DRL indicator lamp relay. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 15

Go to Step 13

8

Inspect the DRL indicator bulb for an open filament or poor connection. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 15

Go to Step 9

9

Inspect for poor connections at the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 15

Go to Step 14

10

Repair an open or high resistance in the DRL indicator control circuit between the DRL indicator lamp relay and splice 336. Refer to Circuit Testing and Wiring Repairs .

Did you complete the repair?

Go to Step 15

--

11

Repair an open or high resistance in the voltage supply circuit of the DRL indicator. Refer to Circuit Testing and Wiring Repairs .

Did you complete the repair?

Go to Step 15

--

12

Repair an open or high resistance in the DRL indicator control circuit between the IPC and the DRL indicator lamp relay. Refer to Circuit Testing and Wiring Repairs .

Did you complete the repair?

Go to Step 15

--

13

Replace the DRL indicator lamp relay.

Did you complete the replacement?

Go to Step 15

--

14

Replace the IPC. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 15

--

15

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 3