GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2005 🢒 Isuzu MD F-Series 🢒 Body 🢒 Lighting Systems 🢒 Tail Lamp Replacement

Removal Procedure
  1. Turn OFF the headlamp switch.

    2. Object Number: 200980 Size: SH
  2. Disconnect the electrical connector from the tail lamp switch.
  3. Remove the bolts from the tail lamp housing.
  4. Remove the tail lamp housing.

Installation Procedure

    Object Number: 200980 Size: SH
  1. Install the tail lamp housing.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolts into the tail lamp housing.

    3. Tighten
    Tighten the bolts to 35 N·m (26 lb ft).

    Important: Install the bolt through the wiring harness clip.

  3. Connect the electrical connector to the tail lamp.