GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the upper steering shaft assembly. Refer to Upper Steering Shaft Assembly Replacement .
  2. Pull the boot away from the upper steering shaft shield.

  3. Object Number: 228496  Size: MH
  4. Mark the position of the upper steering shaft (7) and the upper cardan joint of the lower steering shaft.

  5. Object Number: 228516  Size: SH
  6. Through the access hole in the upper steering shaft shield, remove the following components from the upper cardan joint (1):
  7. 4.1. The cardan bolt (3)
    4.2. The washer

    Object Number: 228520  Size: SH
  8. Gently pry the upper cardan joint off of the upper steering shaft (1).

Installation Procedure


    Object Number: 228520  Size: SH
  1. Align the marks on the lower steering shaft upper cardan joint and the upper steering shaft (1).
  2. Position the lower steering shaft upper cardan joint on to the upper steering shaft (1).

  3. Object Number: 228516  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the following components:
  5. 3.1. The cardan joint
    3.2. The bolt (3) and the washer

    Tighten
    Tighten the cardan bolt to 55 N·m (41 lb ft).

  6. Assemble the boot to the upper steering shaft shield.

  7. Object Number: 228496  Size: MH
  8. Install the upper shaft assembly (7).