GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2007 🢒 Isuzu MD F-Series 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Crankshaft Position Sensor Replacement

Removal Procedure

    Object Number: 1369907 Size: SH

    Important: For engines equipped with an automatic transmission, the sensor is located at the top rear of the engine block. For vehicles equipped with a manual transmission, the sensor (1) is located at the bottom of the engine.

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Disconnect the electrical connector from the crankshaft position (CKP) sensor (1).
  3. Loosen the CKP sensor retaining bolt.
  4. Remove the CKP sensor and clip.

Installation Procedure

    Object Number: 1369907 Size: SH
  1. Install the CKP sensor (1).

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the CKP sensor retaining bolt.

    3. Tighten
    Tighten the bolt to 6 N·m (53 lb in).

  3. Connect the electrical connector to the CKP sensor.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.