GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2007 🢒 Isuzu MD F-Series 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Exhaust Gas Recirculation Cooler Temperature Sensor Replacement - Position 1

Removal Procedure

    Object Number: 1862113 Size: SH
  1. Tilt the cab. Refer to Cab Tilting.
  2. Disconnect the temperature sensor electrical connector.
  3. Remove the temperature sensor from the exhaust gas recirculation (EGR) cooler.

Inspection Procedure
  1. Inspect the sensor for damage.
  2. Replace the sensor if worn or damaged.

Installation Procedure

    Notice: Refer to Component Fastener Tightening Notice in the Preface section.


    Object Number: 1862113 Size: SH
  1. Install the sensor into the EGR cooler.

    2. Tighten
    Tighten the sensor to 44 N·m (33 lb ft).

  2. Connect the electrical connector.
  3. Lower the cab.