The cruise engagement switch is part of the multifunction lever assembly. The cruise control switch is not serviceable. This switch and the multifunction lever must be replaced as an assembly. Refer to Turn Signal Multifunction Switch Replacement.

For the auto cruise ON/OFF switch, perform the following:

1. Remove the cluster trim. Refer to Instrument Panel Carrier Replacement .
2. Remove the switch plate screw.
3. Pull down on the switch plate so that the switch plate tab is disengaged from the dash. Remove the switch plate from the dash enough to gain access to the switch electrical connector.
4. Disconnect the switch electrical connector.
5. Squeeze the switch tabs and remove the switch from the switch plate.

1. Install the switch into the switch plate.
2. Connect the switch electrical connector.
3. Position the switch plate tab into the dash tab locator and secure the switch plate to the dash with the screw.



4. Install the cluster trim. Refer to Instrument Panel Carrier Replacement.