Removal Procedure
- Exhaust all air pressure from the system.
- Remove the screws from the transmission shift sheath.
- Slide the sheath down the shift lever.
- If equipped with the 9 speed transmission, disconnect the following tubes:
| • | Red tube (1) from the S port |
| • | Black tube (2) from the P port |
- If equipped with the 10 speed transmission, disconnect the following tubes:
| • | Blue tube (1) from the SP port |
| • | Black tube (2) from the P port |
| • | Red tube (3) from the S port |
| • | Green tube (4) from the H port to L port |
- Perform the following steps in order to remove the air shift control lever:
| 6.1. | Loosen the shift knob lock nut. |
| 6.2. | Unscrew the shift knob. |
- Remove the shift lever sheath.
- Remove the transmission control lever. Refer to
Control Lever and/or Boot Replacement
.
- Raise and suitably support the vehicle, if required. Refer to
Lifting and Jacking the Vehicle
.
- If equipped with the 9 speed transmission, disconnect the following tubes:
| • | Red tube (1) from the S port |
| • | Black tube (2) from the P port |
- If equipped with the 10 speed transmission, disconnect the following tubes:
| • | Green tube (1) from the H port to L port |
| • | Black tube (2) from the P port |
| • | Blue tube (3) from the SP port |
| • | Red tube (4) from the S port |
- Remove the air shift harness from the vehicle.
Installation Procedure
- Install the air shift harness to the vehicle.
- If equipped with the 10 speed transmission, connect the following tubes:
| • | Green tube (1) to the H port to L port |
| • | Black tube (2) to the P port |
| • | Blue tube (3) to the SP port |
| • | Red tube (4) to the S port |
- If equipped with the 9 speed transmission, connect the following tubes:
| • | Red tube (1) to the S port |
| • | Black tube (2) to the P port |
- Lower the vehicle, if required.
- Install the transmission control lever. Refer to
Control Lever and/or Boot Replacement
.
- Install the shift lever sheath.
Notice: Refer to Fastener Notice in the Preface section.
- Perform the following steps in order to install the air shift control lever:
| 7.1. | Screw the shift knob on completely, then back off until the knob or selector button points to the driver side of the cab. |
| 7.2. | Tighten the shift knob lock nut against the shift knob. |
Tighten
Tighten the shift knob lock nut to 25 N·m (18 lb ft).
- If equipped with the 10 speed transmission, connect the following tubes:
| • | Blue tube (1) to the SP port |
| • | Black tube (2) to the P port |
| • | Red tube (3) to the S port |
| • | Green tube (4) to the H port to L port |
- If equipped with the 9 speed transmission, connect the following tubes:
| • | Red tube (1) to the S port |
| • | Black tube (2) to the P port |
- Slide the sheath up the shift lever.
- Install the screws to the transmission shift sheath.
Tighten
Tighten the control lever sheath screws to 5 N·m (44 lb in).
- Pressurize the system.
- Operate the shift control valve to check for leaks.
