Stabilizer Shaft Replacement Spring Mounted

Remove the following components from the springs:

1. The nuts (5)
2. The washers (6)
3. The shaft mounting brackets (4)
4. The stabilizer shaft (7)
5. The shims (2, 3)

1. Install the following components to the springs:

1.1.	The shims (2, 3)

Important: Install the shim (3) with the dimple protruding towards the stabilizer bar.

1.2.	The stabilizer shaft (7), aligning the indentation and the dimple on the shim (3)

1.3.	The shaft mounting brackets (4)

1.4.	The washers (6)

1.5.	The nuts (5)

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Tighten the stabilizer nuts (5) alternately and evenly until the shaft mounting brackets (4) contact the lower shim (3).

Tighten
Tighten the stabilizer nuts to 170 N·m (125 lb ft).