Brake Pads Replacement Front, Bendix

Removal Procedure

1. Remove the brake caliper (5). Refer to Brake Caliper Replacement .
2. Remove the inner brake pad from the brake caliper mounting plate (4).



3. Slide the outer brake pad along the rail in the brake caliper housing to the notches.
4. Remove the outer brake pad.
5. Inspect the brake caliper. Refer to Brake Caliper Replacement .

Installation Procedure

1. Install the outer brake pad into the brake caliper housing.
2. Install the inner brake pad onto the brake caliper mounting plate.



3. Install the brake caliper (5). Refer to Brake Caliper Replacement .

Brake Pads Replacement Front, Dayton-Walther

Removal Procedure

1. Remove the brake caliper (5). Refer to Brake Caliper Replacement .



2. Slide the outer brake pad along the rail in the brake caliper housing to the notches.
3. Remove the outer brake pad.
4. Slide the inner brake pad along the rail in the brake caliper housing to the notches.
5. Remove the inner brake pad.




Important: Either remove one factory installed Z spring from the brake caliper or remove two service kit springs from the brake pads, if equipped.

6. Remove the retainer spring(s).
7. Inspect the brake caliper. Refer to Brake Caliper Replacement .

Installation Procedure

1. Install one service kit brake pad retainer spring on each brake pad.
2. Reuse the Z spring if the Z spring is undamaged. Discard the service springs if the Z spring is used.



3. Install the inner brake pad.
4. Install the outer brake pad.



5. Install the brake caliper (5). Refer to Brake Caliper Replacement .

Brake Pads Replacement Rear, Bendix Rail Slider

Removal Procedure

1. Remove the brake caliper (5). Refer to Brake Caliper Replacement .
2. Remove the inner brake pad from the brake caliper mounting plate (4).



3. Slide the outer brake pad along the rail in the brake caliper housing to the notches.
4. Remove the outer brake pad.
5. Inspect the brake caliper. Refer to Brake Caliper Replacement .

Installation Procedure

1. Install the outer brake pad into the brake caliper housing.
2. Install the inner brake pad onto the brake caliper mounting plate.



3. Install the brake caliper (5). Refer to Brake Caliper Replacement .

Brake Pads Replacement Rear, Dayton-WaltherRailSlider

Removal Procedure

1. Remove the brake caliper (5). Refer to Brake Caliper Replacement .



2. Slide the outer brake pad along the rail in the brake caliper housing to the notches.
3. Remove the outer brake pad.
4. Slide the inner brake pad along the rail in the brake caliper housing to the notches.
5. Remove the inner brake pad.




Important: Either remove one factory installed Z spring from the brake caliper or remove two service kit springs from the brake pads, if equipped.

6. Remove the brake pad retainer spring.
7. Inspect the brake caliper. Refer to Brake Caliper Replacement .

Installation Procedure

1. Install one service kit brake pad retainer spring on each brake pad.
2. Reuse the Z spring if the Z spring is undamaged. Discard the service springs if the Z spring is used.



3. Install the inner brake pad.
4. Install the outer brake pad.



5. Install the brake caliper (5). Refer to Brake Caliper Replacement .