GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 36221 J 36221 Hydraulic Clutch Line Separator

J 42371 J 42371 Hydraulic Clutch Line Separator

Removal Procedure

  1. Remove the clutch cylinder hose from the hose retaining clip.

  2. Object Number: 71472  Size: SH
  3. Using the J 36221 or J 42371 , depress the white circular release ring on the actuator hose and simultaneously pull lightly on the master cylinder hose to disconnect.
  4. Protect both hose coupling ends from dirt and damage.

  5. Object Number: 884801  Size: SH
  6. Remove the two bolts and washer securing the clutch pedal and clutch cylinder to the panel.
  7. Remove the clutch pedal from the clutch cylinder.

Installation Procedure


    Object Number: 884801  Size: SH
  1. Install the clutch pedal to the clutch cylinder.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the two bolts and washers securing the clutch pedal and clutch cylinder to the panel.
  4. Tighten
    Tighten the clutch pedal bolts to 85 N·m(63 ft lb).


    Object Number: 71472  Size: SH

    Important: DO NOT rely on an audible click or a visual verification of the clutch hydraulic hose quick connect fitting connection.

  5. Connect the clutch actuator cylinder hose to the clutch master cylinder hose.
  6. Push together the clutch hydraulic hose quick connect fittings, then pull back on the fittings to verify engagement.

  7. Check the hydraulic hoses for twists or kinks.
  8. Install the clutch actuator cylinder hose to the hose retaining clip.