Removal Procedure
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect the negative battery cables.
- Remove the dome lamp lens.
- Remove the dome lamp bulb.
3.1. | Grasp the bulb in the center. |
3.2. | Push the bulb toward one of the spring clips in order to free
the other end of the bulb. |
- Remove the two retaining screws from the lamp housing.
- Remove the dome lamp housing.
- Disconnect the electrical connector.
Installation Procedure
- Connect the electrical connector.
- Install the dome lamp
housing to the roof with the three retaining screws.
- Install the dome lamp bulb by pushing the bulb straight into the
lamp housing until the bulb is fully seated.
- Install the dome lamp lens.
- Connect the negative battery cables.