Floor Carpet Drying for Isuzu Isuzu MD Steel Tilt (F Model) 2000
If the carpet or the pad or insulator is wet,
use the following criteria for drying or for replacing the components:
| • | For a 1-piece carpet assembly bonded to a cotton or a fiber padding,
replace the entire assembly. |
| • | For a 2-piece carpet assembly with a cotton or a fiber padding,
replace the padding only. While the carpet is out of the vehicle, dry the
carpet using the method described below. |
| • | For a 1-piece carpet assembly bonded to a foam padding or attached
to a synthetic padding, dry the carpet using the method described below. |
| • | For a 2-piece carpet assembly with a synthetic padding, dry the
assembly using the method described below. |
Drying Method
- If you observe puddles of liquid on the carpet face, use a wet
vacuum to remove the excess moisture.
- Blot the face of the carpet with a towel in order to absorb as
much moisture as possible.
- Point a fan at the affected area and air dry the carpet.
