Removal Procedure
- Remove the battery carrier cover.
- Remove the negative cable from the negative battery terminal.
- Remove the positive cable from the positive battery terminal.
- Remove the battery hold-down retainer.
- Remove the battery from the carrier.
- Inspect the following components for damage:
- Clean the components as necessary.
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
| • | The battery |
| • | The cables and the connectors |
| • | The carrier |
Correct any evident damage.
Installation Procedure
- Install the battery into the cleaned carrier.
- Install the battery hold-down retainer or top bar and nut.
- Connect the positive cable to the positive battery terminal.
- Connect the negative cable to the negative battery terminal.
- Install the battery carrier cover.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the top bar nut to 17 N·m (13 lb ft).
Tighten
Tighten the top post terminal nut to 17 N·m (13 lb ft).
