Tools required
• | J 41220 Slinger
Remover and Installer |
• | J 41221 Oil
Seal Remover and Installer |
- Apply clean engine oil to the oil slinger.
- Insert the oil slinger into the adapter.
- Install the oil slinger sleeve to the adapter.
- Using the J 41220
, install the oil slinger.
- After pressing in the
oil slinger, make sure that the distance between the crankshaft end surface
and the oil slinger is 10.35 10.65 mm (0.407-0.419
in) by checking the measurement at several different points.
- Apply clean engine oil to the oil seal.
- Insert the oil seal adapter.
- Using the J 41220
install the oil seal to the adapter, and tighten the center bolt until
the sleeve comes in contact with the adapter and stops.
- After pressing in the
oil seal, make sure that the distance between the crankshaft end surface and
the oil slinger is 7.35-7.65 mm (0.289-0.301 in.) by
checking the measurement at several different points.