Notice: Use J 36850 or equivalent during assembly in order to retain
checkballs or to lubricate components. Lubricants other than the recommended
assembly lube changes the transmission fluid characteristics and
causes undesirable shift conditions or filter clogging.
- Install the 8 checkballs (54) (9 some models) into the case passages:
• | The #2 checkball is only used on some models. |
• | Use J 36850
or equivalent in order to hold the checkballs in place. |
- Install the PWM solenoid screen (75) into the case.
- Install the manual valve
(319) into the control valve assembly.
- Install the J 25025-5
into the transmission case.
- Install the spacer plate to case gasket (48).
- Install the control valve assembly (44). Attach the manual valve
to the detent lever while installing the control valve assembly (44).
- Install the transmission
fluid pressure manual valve position switch (40).
- Install the transmission fluid pressure manual valve position
switch bolts (76) finger tight.
- Tighten the bolts (76)
in the order shown.
Tighten
Tighten the bolts to 11 N·m (97 lb in).
Refer to Fastener Notice
.
- Remove the J 25025-5
.
- Install the manual shaft
detent spring assembly (41) and bolts (35).
- Install the two wiring harness clamps (33) and bolts (35).
- Install the lube oil pipe (39) with the short end into the control
valve assembly.
- Install the lube oil pipe retainer (37) and the bolt (35).
- Install the remaining control valve body assembly bolts (35).
Notice: Tighten the control valve assembly bolts in a spiral pattern starting
from the center. If the bolts are tightened in a random pattern, the valve
bores may become distorted, which can inhibit valve operation.
- Tighten the control valve body assembly bolts (35) in the order shown.
Tighten
Tighten the bolts to 11 N·m (97 lb in).