Removal Procedure
Notice:
ā¢ | Handle the MAF sensor carefully. |
ā¢ | Do not drop the MAF sensor in order to prevent damage to the MAF
sensor. |
ā¢ | Do not damage the screen located on the air inlet
end of the MAF. |
ā¢ | Do not touch the sensing elements. |
ā¢ | Do not allow solvents and lubricants to come in contact with the
sensing elements. |
ā¢ | Use a small amount of a soap based solution in order to aid in
the installation. |
- Turn OFF the ignition.
- Disconnect the MAF sensor
(5) harness connector.
- Remove the bolts that secure the front air filter housing tabs (3).
- Loosen the clamps on the MAF sensor.
- Carefully remove the MAF sensor from the air intake ducts.
Installation Procedure
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
Important: Ensure that the MAF sensor flow arrows point away from the air cleaner
assembly.
- Install the MAF sensor into the air intake ducts.
- Tighten the clamps on the MAF sensor.
Tighten
Tighten the clamps to 4 NĀ·m (35 lb in).
- Install the bolts that secure the front air filter housing tabs (3).
- Connect the MAF sensor (5)
harness connector.
- Start the engine and inspect for air leaks.