GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Isuzu 🢒 2009 🢒 Isuzu - N Series 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Replacement

Removal Procedure

Note: Clean the area around the camshaft position (CMP) sensor before removal in order to prevent debris from entering the engine.

  1. Remove the engine cover.

    2. Object Number: 260128 Size: SH
  2. Disconnect the CMP sensor electrical connector.
  3. Remove the CMP sensor bolt.
  4. Remove the CMP sensor.

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 260128 Size: SH
  1. Install the CMP sensor.
  2. Install the CMP sensor bolt.

    3. Tighten
    Tighten the bolt to 25 N·m (18 lb ft).

  3. Connect the CMP sensor electrical connector.
  4. Install the engine cover.