| Table 1: | Engine Data 1 |
| Table 2: | Engine Data 2 |
| Table 3: | Engine Data 3 |
| Table 4: | HO2S Data |
| Table 5: | Misfire Data |
| Table 6: | EVAP Data |
Use the scan tool data listed in this table for comparison after the On-Board Diagnostic system check has been performed and after finding the on-board diagnostics are functioning properly with no diagnostic codes displayed.
The Typical Scan Tool Data Values are an average of display values recorded from normally operating vehicles. The Typical Scan Tool Data Values are intended to represent what a normally functioning system would display. The values you get may vary due to a low battery charge or other reasons. But they should be very close.
Do not use a scan tool that displays malfunctioning data. Report the problem to the manufacturer. The use of a malfunctioning scan tool can result in misdiagnosis and unnecessary parts replacement.
Use only the parameters listed in the tables for diagnosis. If a scan tool reads other parameters, the values are not recommended for use in diagnosis. For more description on the values and the use of the scan tool in diagnosing the VCM inputs, refer to the applicable diagnosis. If all of the values are within the range illustrated, refer to Driveability Symptoms.
Scan Tool Data Display
Engine at Operating Temp/Engine Idling in Closed Loop/Closed Throttle/Park or Neutral/Accessories OFF | ||
|---|---|---|
Scan Position | Units Displayed | Typical Data Value |
Engine Speed | RPM | 600-650 RPM |
Desired Idle | RPM | 600-650 RPM |
Startup ECT | Degrees | Varies |
ECT | Degrees | 93°C (200°F) |
Startup IAT | Degrees | Varies |
IAT | Degrees | Varies |
IAT Sensor | Volts | Varies |
Air Fuel Ratio | Ratio | 14.7:1 |
IAC Position | Counts | Varies |
Desired IAC | Counts | Varies |
TP Sensor | Volts | 0.47-0.55 Volts |
TP Angle | % | 0% |
MAP | kPa | 30-35 kPa |
MAP | Volts | 1.07-1.31 Volts |
BARO | kPa | 95 kPa |
BARO | Volts | 4.58 Volts |
Ignition 1 | Volts | 13.5 Volts |
Engine Speed | RPM | 600-650 RPM |
Long Term FT Bank 1 | % | 0% |
Long Term FT Bank 1 | Counts | 127 Counts |
Long Term FT Bank 2 | % | -3% |
Long Term FT Bank 2 | Counts | 123 Counts |
Short Term FT Bank 1 | % | 0% |
Short Term FT Bank 1 | Counts | 128 Counts |
Short Term FT Bank 2 | % | 0% |
Short Term FT Bank 2 | Counts | 128 Counts |
Fuel Trim Cell Bank 1 | Cell | Cell 17-19 |
Fuel Trim Cell Bank 2 | Cell | Cell 17-19 |
KS Activity | Counts | 0-230 Counts |
Knock Sensor | Volts | 4.76 Volts |
Spark | Degrees | 20° |
Knock Retard | Degrees | 0° |
CMP Retard | Degrees | -15° - 0° |
Engine Run Time | Min/Sec | Varies |
Scan Tool Data Display
Engine at Operating Temp/Engine Idling in Closed Loop/Closed Throttle/Park or Neutral/Accessories OFF | ||
|---|---|---|
Scan Position | Units Displayed | Typical Data Value |
Engine Speed | RPM | 600-650 RPM |
Desired Idle | RPM | 600-650 RPM |
EVAP Duty Cycle | % | 13%-17% |
EVAP Canister Purge | Off/On | On |
Air Fuel Ratio | Ratio | 14.7:1 |
EGR Duty Cycle | % | 0% |
Actual EGR Position | % | 0% |
Desired EGR Position | % | 0% |
EGR Sensor | Volts | 0.51-0.64 Volts |
Air Fuel Ratio | Ratio | 14.7:1 |
Ignition 1 | Volts | 13.6 Volts |
IAC Position | Counts | Varies |
Desired IAC | Counts | Varies |
ECT | Degrees | 93°C (200°F) |
Start Up ECT | Degrees | Varies |
IAT | Degrees | Varies |
CMP Retard | Degrees | -15° - 0° |
Spark Control | Retard/Advance | Advance |
Power Enrichment | Inactive/Active | Inactive |
Brake Switch | Closed/Open | Closed |
Clutch Pedal Switch | Released/Applied | Released |
TR Switch | Park/Neutral | Park/Neutral |
A/B/C Range Switch | OFF ON OFF | OFF ON OFF |
Vehicle Speed | km/h | 0 km/h |
Decel Fuel Mode | Inactive/Active | Inactive |
TP Sensor | Volts | .47-.53 Volts |
TP Sensor | % | 0% |
MAP | kPa | 30-35 kPa |
MAP | Volts | 1.07-1.31 Volts |
BARO | kPa | 95 kPa |
BARO | Volts | 4.58 Volts |
1-2 Sol. | Off/On | On |
2-3 Sol. | Off/On | On |
3-2 Downshift Sol. | Off/On | On |
TCC Enable | No/Yes | No |
TCC Duty Cycle | % | 0% |
TCC Slip Speed | RPM | 600-650 RPM |
Cruise Mode | Off/On | Off |
Engine Run Time | Min/Sec | Varies |
Scan Tool Data Display
Engine at Operating Temp/Engine Idling in Closed Loop/Closed Throttle/Park or Neutral/Accessories OFF | ||
|---|---|---|
Scan Position | Units Displayed | Typical Data Value |
Engine Speed | RPM | 600-650 RPM |
Desired Idle | RPM | 600-650 RPM |
IAC Position | Counts | 38 Counts |
Desired IAC | Counts | 38 Counts |
INJ. PWM Average Bank 1 | ms | 3.0-3.6 ms |
INJ PWM Average Bank 2 | ms | 3.0-3.6 ms |
Engine Load | % | 17%-23% |
MAF Frequency | Hz | 2190-2443 Hz |
MAF | g/s | 4.2-5.3 g/s |
TP Sensor | Volts | 0.47-0.51 Volts |
TP Angle | % | 0% |
MAP | kPa | 30-35 kPa |
MAP | Volts | 1.07-1.31 Volts |
BARO | kPa | 95 kPa |
BARO | Volts | 4.58 Volts |
EVAP Duty Cycle | % | 17%-19% |
EGR Duty Cycle | % | 0% |
Actual EGR Position | % | 0% |
Desired EGR Position | % | 0% |
EGR Sensor | Volts | 0.51-0.64 Volts |
CMP Retard | Degrees | -15° - 0° |
A/C Request | No/Yes | No |
A/C Relay | Off/On | Off |
Engine Run Time | Min/Sec | Varies |
Scan Tool Data Display
Engine at Operating Temp/Engine Idling in Closed Loop/Closed Throttle/Park or Neutral/Accessories OFF | ||
|---|---|---|
Scan Position | Units Displayed | Typical Data Value |
Engine Speed | RPM | 600-650 RPM |
Desired Idle | RPM | 600-650 RPM |
Pre HO2S | Not Ready/Ready | Ready |
Post HO2S | Not Ready/Ready | Ready |
HO2S Bank 1 Sensor 1 | mV | Varies |
HO2S Bank 1 Sensor 2 | mV | Varies |
HO2S Bank 2 Sensor 1 | mV | Varies |
HO2S Bank 1 Sensor 3 | mV | Varies |
Air Fuel Ratio | Ratio | 14.7:1 |
HO2S XCounts Bank 1 | Counts | Varies |
HO2S XCounts Bank 2 | Counts | Varies |
Rich/Lean Bank 1 | Rich/Lean | Varies |
Rich/Lean Bank 2 | Rich/Lean | Varies |
Loop Status | Closed/Open | Closed |
Cl Since Restart | No/Yes | Yes |
IAC Position | Counts | Varies |
Desired IAC | Counts | Varies |
MAF | g/s | 4.2-5.3 g/s |
Long Term FT Bank 1 | % | 0% |
Long Term FT Bank 1 | Counts | 127 Counts |
Long Term FT Bank 2 | % | -3% |
Long Term FT Bank 2 | Counts | 123 Counts |
Short Term FT Bank 1 | % | 0% |
Short Term FT Bank 1 | Counts | 128 Counts |
Short Term FT Bank 2 | % | 0% |
Short Term FT Bank 2 | Counts | 128 Counts |
Long Term Fuel Trim | Disenabled/Enabled | Enabled |
Fuel Trim Cell Bank 1 | Cell | Cell 17-19 |
Fuel Trim Cell Bank 2 | Cell | Cell 17-19 |
ECT | Degrees | 93°C (200°F) |
Startup ECT | Degrees | Varies |
Ignition 1 | Volts | 13.6 Volts |
Engine Run Time | Min/Sec | Varies |
Scan Tool Data Display
Engine at Operating Temp/Engine Idling in Closed Loop/Closed Throttle/Park or Neutral/Accessories OFF | ||
|---|---|---|
Scan Position | Units Displayed | Typical Data Value |
Engine Speed | RPM | 600-650 RPM |
Desired Idle | RPM | 600-650 RPM |
Misfire Current Cyl. #1 | Number of Misfires | 0 |
Misfire Current Cyl. #2 | Number of Misfires | 0 |
Misfire Current Cyl. #3 | Number of Misfires | 0 |
Misfire Current Cyl. #4 | Number of Misfires | 0 |
Misfire Current Cyl. #5 | Number of Misfires | 0 |
Misfire Current Cyl. #6 | Number of Misfires | 0 |
Cycles of Misfire Data | Number of Cycles | Varies |
Engine Speed | RPM | 600-650 RPM |
Desired Idle | RPM | 600-650 RPM |
Misfire History Cyl. #1 | Number of Misfires | 0 |
Misfire History Cyl. #2 | Number of Misfires | 0 |
Misfire History Cyl. #3 | Number of Misfires | 0 |
Misfire History Cyl. #4 | Number of Misfires | 0 |
Misfire History Cyl. #5 | Number of Misfires | 0 |
Misfire History Cyl. #6 | Number of Misfires | 0 |
Misfire Per Cycle Status | Counts | Varies |
IAC Position | Counts | 36 Counts |
Desired IAC | Counts | 36 Counts |
Ignition 1 On | No/Yes | Yes |
IAC Position | Counts | Varies |
Desired IAC | Counts | Varies |
Rich/Lean Bank 1 | Rich/Lean | Varies |
Rich/Lean Bank 2 | Rich/Lean | Varies |
A/C Relay | Off/On | Off |
A/C Request | No/Yes | No |
Brake Switch Closed | Closed/Open | Closed |
FT Enable | Off/On | On |
Decel Fuel Mode | Inactive/Active | Inactive |
Power Enrichment | Off/On | Off |
TR Switch | Park/Neutral | Park/Neutral |
TCC Forced Off | No/Yes | Yes |
TCC Enable | No/Yes | No |
Vehicle Speed | km/h | 0 km/h |
Cruise Mode | No/Yes | No |
Scan Tool Data Display
Engine at Operating Temp/Engine Idling in Closed Loop/Closed Throttle/Park or Neutral/Accessories OFF | ||
|---|---|---|
Scan Position | Units Displayed | Typical Data Value |
MAP | kPa | 30-35 kPa |
MAP | Volts | 1.07-1.31 Volts |
TP Sensor | Volts | 0.47-0.55 Volts |
TP Angle | % | 0% |
Fuel Level | % | Varies |
Fuel Level Sensor | Volts | Varies |
Fuel Tank Pressure | in. H20 | Varies |
Weak Vacuum Test | Not Run/Fail | Not Run/Fail |
Small Leak Test | Not Run/Fail | Not Run/Fail |
Purge Leak Test | Not Run/Fail | Not Run/Fail |
Excess Vacuum Test | Not Run/Fail | Not Run/Fail |
EVAP Canister Purge | Off/On | On |
EVAP Vent Solenoid | Closed/Open | Open |
EVAP Duty Cycle | % | 17%-19% |
Engine Run Time | Min/Sec | Varies |
