1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Place a drain pan under the transmission oil pan.
3. Remove the oil pan drain plug.



4. Remove the oil pan bolts.



5. Remove the oil pan and the gasket.



6. Remove the fluid filter and the seal.
7. Retain the seal for reuse.

Tools Required

J 36850

1. Coat the seal with a small amount of J 36850 , or equivalent.



2. Install the new filter neck seal into the transmission case.
3. Install the filter into the case.



4. Install the oil pan and a new gasket.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

5. Install the oil pan bolts.

Tighten
Oil pan to transmission case bolts to 11 N·m (97 lb in).

6. Apply a small amount of sealant to the threads of the oil pan drain plug.
7. Install the oil pan drain plug.

Tighten
Oil pan drain plug to 18 N·m (13 lb ft).

8. Lower the vehicle.
9. Fill the transmission to the proper level. Use DEXRON® III automatic transmission fluid.