Important: Inspect for mechanical binding and ensure that the transmission linkage is adjusted properly prior to performing this diagnostic procedure.

Did you perform the BTSI System Check?

--

Go to Step 2

Go to Automatic Transmission Shift Lock Control System Check

1. Disconnect the TCC/stoplamp switch.
2. Use a J 39200 DMM in order to test the TCC/stoplamp switch for proper operation.

Does the TCC/stoplamp switch operate properly?

--

Go to Step 4

Go to Step 3

Replace the TCC/stoplamp switch. Refer to Stop Lamp Switch Replacement .

Is the repair complete?

--

Go to Automatic Transmission Shift Lock Control System Check

--

1. Turn the ignition switch to the ON position. Do not start the engine.
2. Connect a test lamp between the TCC/stoplamp switch connector terminal F and ground.

Does the test lamp light?

--

Go to Step 6

Go to Step 5

Locate and repair a short to power in CKT 1135 (DK GRN/WHT).

Is the repair complete?

--

Go to Automatic Transmission Shift Lock Control System Check

--

Replace the BTSI solenoid.

Is the repair complete?

--

Go to Automatic Transmission Shift Lock Control System Check

--