Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle Column Shift

Important: The electrical contact of the turn signal and multifunction switch assembly (2) must rest on the turn signal cancel cam assembly.

1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).

Tighten
Tighten the 2 pan head tapping screws to 7 N·m (62 lb in).




3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).



4. Reconnect the turn signal and multifunction switch assembly connector to the SRS coil assembly connector.
5. Attach the wire harness assembly (1) to the steering column wire harness strap (2).
6. Install the upper and lower shrouds. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle .

Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle Floor Shift

1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

Important: The electrical contact of the turn signal and multifunction switch assembly (2) must rest on the turn signal cancel cam assembly.

2. Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).

Tighten
Tighten the 2 pan head tapping screws to 7 N·m (62 lb in).




3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).



4. Reconnect the turn signal and multifunction switch assembly connector to the SRS coil assembly connector.
5. Attach the wire harness assembly (1) to the steering column wire harness strap (2).
6. Install the upper and lower shrouds. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle .