Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle Column Shift

1. Slide the ignition and key alarm switch assembly (3) into the lock module assembly (1).



2. Push the key alarm connector (1) into the lock module assembly (2).
3. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
4. Install the Pass-Key® connector into the lock module assembly (2).



5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).



6. Attach the wire harness assembly (1) to the wire harness strap (2).
7. Install the upper and lower shrouds. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle .

Ignition and Key Alarm Switch Assembly - Assemble - Off Vehicle Floor Shift

1. Slide the ignition and key alarm switch assembly (3) into the lock module assembly (1).



2. Install the key alarm connector (1) into the lock module assembly (2).

2.1.	Push the key alarm connector (1) into the lock module assembly (2).

2.2.	Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.

2.3.	Install the Pass-Key® connector into the lock module assembly (2).




3. Snap the electric park lock (2) onto the lock module assembly (1).



4. Reconnect the connector (2) to the electric park lock (1).



5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).



6. Attach the wire harness assembly (1) to the steering column wire harness strap (2).
7. Install the upper and lower shrouds. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle .