Was the Wiper/Washer System Check performed?

--

Go to Step 2

Go to Wiper/Washer System Check

1. Turn the ignition to OFF.
2. Disconnect wiper/washer switch connector C211.
3. Turn the wiper switch to DELAY.
4. Measure the resistance from wiper/washer switch connector C211, terminal E4 to terminal E5, with a J 39200 set to the ohms scale.
5. Move the wiper switch through the entire delay range, one notch at a time.

Does the resistance vary within the specified range?

39 Kohms to 680 Kohms

Go to Step 4

Go to Step 3

Replace the wiper/washer switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle with Standard column or Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle with Tilt column.

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

1. Reconnect the wiper/washer switch connector C211.
2. Disconnect the wiper motor connector.
3. Turn the ignition switch to RUN.
4. Turn the wiper switch to DELAY.
5. Measure the voltage from the wiper motor connector, terminal E, to ground using a J 39200 .

Is the measurement within the specified value?

10.5-15 V

Go to Step 6

Go to Step 5

Check for a poor connection or an open in CKT 112.

Is a poor connection or an open present?

--

Go to Step 7

Go to Step 8

Replace the wiper motor module. Refer to Windshield Wiper System Module Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--

Repair the poor connection or the open in CKT 112.

Is the repair complete?

--

Go to Wiper/Washer System Check

--

Replace the wiper motor. Refer to Windshield Wiper Motor Replacement .

Is the replacement complete?

--

Go to Wiper/Washer System Check

--