Replacing the body control module (BCM) may be necessary when you service the body control system.

Important: The ignition switch should be in the OFF position when connecting or disconnecting the connectors to the BCM. Always disconnect the Brown BCM connector FIRST and connect the Brown BCM connector LAST. The BCM can set DTC(s) with the ignition switch in the OFF position. The BCM has battery run down protection for the courtesy lamp circuit. The BCM battery run down protection can not detect shorts on inputs or other circuits which it does not control. The scan tool can be used to put the BCM to sleep in order to check for current draws on circuits which are not controlled by the BCM or controlled by the battery run down protection system. If an excessive current draw is detected, refer to Battery Electrical Drain/Parasitic Load Test in Engine Electrical.

1. Remove the left instrument panel sound insulator from the vehicle. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.
2. Remove the center instrument panel sound insulator from the vehicle. Refer to Instrument Panel Lower Center Trim Replacement in Instrument Panel, Gauges and Console.
3. Disconnect the electrical connectors from the body control module.
4. Bend the 2 snap retainers back slightly and pull the body control module from the bracket at an angle.

1. Install the body control module to the bracket at an angle under the wide hook retainer, with the label facing away from the bracket.
2. Apply pressure on the left side of the body control module in order to move the module toward the mounting bracket base. Snap the module into place.
3. Ensure that the module is fully seated. Ensure that both snap retainers are holding the module.
4. Connect the electrical connectors to the body control module.
5. Install the center instrument panel sound insulator to the vehicle. Refer to Instrument Panel Lower Center Trim Replacement in Instrument Panel, Gauges and Console.
6. Install the left instrument panel sound insulator to the vehicle. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gauges and Console.
7. Use the following components in order to program the body control module with the proper calibrations:

•	The ITCS Terminal

•	The scan tool

8. Perform the Learn Procedure.
9. Clear the diagnostic trouble codes (DTCs).