Tools Required

J 36202 Torsion Bar Loading/Unloading Tool

1. Raise and support the vehicle with safety stands. Refer to Lifting and Jacking the Vehicle in General Information.



2. Unload both torsion bars using J 36202 . To aid in assembly, record the number of turns the tool makes when removing the adjusting bolt. Remove J 36202 .



3. Remove the lower link mount nut from one side.
4. Remove the torsion bars. Note the exact direction of the forward end and the side of the torsion bar that is being removed.
5. Remove the lower link mount nut from the opposite side.
6. Remove the lower link mount.



7. Remove the upper link mount nut.
8. Remove the upper link mount.
9. Remove the torsion bar support from the frame.

Tools Required

J 36202 Torsion Bar Loading/Unloading Tool

1. Install the torsion bars in relation to where the bars were removed.



2. Install the torsion bar support.



3. Install the upper link mount.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the upper link mount nut.

Tighten
Tighten the upper link mount nut to 65 N·m (48 lb ft).




5. Install the lower link mount bushing. Place a jack stand under the torsion bar support member.
6. Install the lower link mount nut.

Tighten
Tighten the lower link mount nut to 50 N·m (37 lb ft).




7. Adjust the torsion bar using J 36202 .



8. Tighten the tool against the adjusting arm for the recorded number of turns. This loads the torsion bars.
9. Lower the vehicle.
10. Check final Z trim height. Refer to Trim Height Inspection in Suspension General Diagnosis.